After you purchase a DID on your account, you'll have to assign the connection you wish to receive inbound calls to. DIDsĪ DID is required in order to receive inbound calls to your client.
#X LITE SOFTPHONE PASSWORD#
Note: Once your credential-based Connection is created, you can display the username and password by clicking the eye icon under the "Auth Detail" column. Please make sure you use strong credentials.
These steps will walk through the setup of a credentials based connection. Next, you need to set up a connection to authenticate your client (X-Lite) with our sip proxy ().
#X LITE SOFTPHONE VERIFICATION#
More information on account verification can be found here. To check, visit the ‘My Account’ section of your portal account, and navigate to ‘Verifications’. Most users will already be Level 1 verified following email confirmation on signup. To complete the below steps, you'll need to be Level 1 verified. There are four steps needed to set up your Telnyx Mission Control Portal account so that it’s ready to be configured to your PBX phone system, softphone client or softswitch of your choice. Getting Started with Your Telnyx Mission Control Portal Configure your X-Lite profile for Inbound and Outbound calling.Authenticate your SIP Trunk with X-Lite.Set up your Telnyx SIP Trunk Connection.To connect your Telnyx numbers to your X-Lite platform we need to establish a SIP interface which is completed in these steps: We handle all the complexity in routing calls and delivering crystal clear conversations. With your email address, or register with your Google, Facebook or GitHub account - it only takes a few seconds.Ī Telnyx Elastic SIP Trunk is used to connect your IP-based communications infrastructure to the PSTN, so you can make and receive calls globally with our private IP network.